SunStar 332 Installing
SunStar 332 Installing

SunStar 332 Installing

Installing the body fan

Advertisement

Quick Links

Installing the Body Fan on a SUNSTAR 332 and 432
You will need a #2 Phillips screwdriver to perform this procedure.
1
Open the bench acrylic. At the foot
end, inside the lamp area, remove
the four screws securing the body
fan bracket to the metal endcap. Save
these screws.
Locate the Body Fan Endcap packaged with the Bench.
It can be identified by the slots for the body fan.
3
Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.
2
Remove the two 1/4-20 x 1/2"
screws in the bracket. Again,
save these screws.
4
Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2" screws.
WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
pg. 1
26795-02A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 332 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SunStar 332

  • Page 1 Installing the Body Fan on a SUNSTAR 332 and 432 You will need a #2 Phillips screwdriver to perform this procedure. WARNING Shock hazard. Be sure AC power is not connected before performing this procedure. Open the bench acrylic. At the foot end, inside the lamp area, remove Remove the two 1/4-20 x 1/2”...
  • Page 2 Connect the Body Fan power cord to the cord coming out of the end of the bench. Using two #10 x 1/2” screws in the middle holes and two #10 x 1” screws in the outer holes (supplied in the main hardware kit) attach the endcap to the bench.

This manual is also suitable for:

432

Table of Contents