Advertisement
Installing the Body Fan on a SUNSTAR 332 and 432
You will need a #2 Phillips screwdriver to perform this procedure.
In this kit you should find the following parts:
(4) - #10 x 1/2" Phillips pan head
sheet metal screws
(2) - 1/4-20 x 1/2" Phillips pan head
machine screws with lock washer
Body Fan
Mounting Bracket
Body Fan
1
Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
Locate the Body Fan Endcap packaged with the Bench.
It can be identified by the slots for the body fan.
WARNING
2
Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2" screws.
pg. 1
26795-01A
Advertisement
Table of Contents
Related Manuals for SunStar 332
Summary of Contents for SunStar 332
- Page 1 Installing the Body Fan on a SUNSTAR 332 and 432 You will need a #2 Phillips screwdriver to perform this procedure. In this kit you should find the following parts: WARNING Shock hazard. (4) - #10 x 1/2” Phillips pan head...
- Page 2 Connect the Body Fan power cord to the cord coming out of the end of the bench. Using two #10 x 1/2” screws in the middle holes and two #10 x 1” screws in the outer holes (supplied in the main hardware kit) attach the endcap to the bench.
Need help?
Do you have a question about the 332 and is the answer not in the manual?
Questions and answers