Advertisement
STRAP ATTACHMENT - TO COVER
C.
Choose EITHER Fig. 10 OR Fig. 11 based on your pool shape.
It will be easier if you move the cover away from the pool and fold it if necessary (bubbles in) on a flat surface.
For Reel Systems Placed at Pool End (Rectangular Pools) (Fig.10)
Strap end
Strap Plate
For Reel Systems placed across widest point of Pool (Round, Oval or Irregularly Shaped Pools) (Fig. 11)
Plastic Screw
Strap end
Strap Plate
D.
Place assembled reel across pool at determined location and mark holes for post cones. Attach cones by drilling 1/4" (6.35 mm)
holes in top rail as marked on the cones. Take Care to not drill into pool liner. Cones MUST be level for the system to lift off or swing.
E.
When you start to roll up cover, all straps must take hold of the cover at the same time. Adjust strap length at strap plate
if necessary.
Safe Use of Your Solar Reel:
Solar Reel Systems are designed solely to remove solar covers and are not made to support people or
·
any other weight.
·
Solar covers must be completely removed before entry into the pool. Under no circumstances, should
one swim in a pool partially covered with the solar cover.
Care and Storage:
Check screws periodically and tighten, if necessary. The solar reel may be stored outside
for the winter. It is not recommended to disassemble it for storage
In order to protect the warranty on your solar cover, it is essential to use a protective
cover when the it is rolled up on the reel. In the summer use a White Sheet with
UV inhibitors and in Winter, a Winter Jacket. If not provided, they can be purchased
from your pool retailer.
FeherGuard Accessories available through Pool Retailer:
FG-FASKIT
Tube & Blanket Fastening Kit (10 sets tube & blanket fasteners & 10 - 26" straps / package)
FG-PFS
Tube & Blanket Fasteners (10 sets / package)
FG-RS26
Reel Strapping (10 - 26" Straps / package)
FG-RS50
Reel Strapping (1 Roll 50' Strapping / package)
FG-MPR
Mid-Grip Pull Rope (helps pull Solar Blanket on to Pool - 35' Rope, 2 clips, 2 plates, 2 fasteners / package)
FG-WPS
White Protective Sheet with UV Inhibitors (Wrap to protect solar blanket on the reel 24' x 3 1/2' / package)
FG-BS2X6
Blanket Straps (secures rolled up Solar Blanket on Reel - 2 x 54" straps with buckles / package)
(Solar Blanket)
Plastic Screw
Cover
(bubbles
down)
Fig. 10
Cover is
folded
"Pinched Fold"
(bubbles in)
Fig. 11
Pierce hole through cover, 1" (2.5 cm) back from
edge of cover and straight down (perpendicular)
from a strap already attached to tube. Push
threaded plastic screw through hole in cover
then tighten snugly into plate. Repeat for
remaining straps.
Fold cover where system will be placed
(bubbles in). Pierce hole through both sides of
cover, 1" (2.5 cm) back from the fold and
straight down (perpendicular) from a strap
already attached to tube. Push threaded plastic
screw through holes in cover then tighten
snugly into plate. Repeat for remaining straps.
Place straps evenly
along fold.
Pinched fold
HV-WCR
Advertisement
