Advertisement
LED status indications
Description of state
Standby mode, no wireless device subscribed
In registration mode (duration 10 seconds)
Standby, wireless device subscribed
Ready to enter deregistration mode
After deregistration mode has been confirmed:
1. Duration: 3 seconds
2. Duration: 1 second
3. Back in standby, no wireless device subscribed
Compatible with:
Wireless headsets Snom A170, A150; wireless speakerphone Snom C52-SP
Pairing with A170/A150 headsets
1. Deregister the headset from its base station or from another dongle it may have been paired with. Please
refer to the user instructions of the headset or the dongle on how to do it. When the headset has been
deregistered, its LED blinks red and green alternatingly.
2. Press the key on the A230 for 4 seconds, then place the headset in its charger. The A230's red LED
double-flashes rapidly and turns off when the registration has been successful, while the headset's LED
shows steady light (green if fully charged, red if charging).
Pairing with C52SP speakerphone
NOTE: If the speakerphone was previously registered to another DECT dongle or a C520-WiMi conference
phone, it must be deregistered first.
◦ For the deregistration from another A230 DECT dongle, see reverse side.
◦ For the deregistration from the C520-WiMi, please refer to the C520-WiMi user manual.
NOTE: The C52SP's battery must be fully charged, and the device must be connected to a wall outlet via
its power adapter. Keep distance between C52SP and A230 at < 30 cm until pairing was successful.
1. Press the white registration button underneath the battery compartment on the bottom
of the speakerphone for 5 seconds until the speakerphone's LEDs start flashing red and
green alternatingly.
2. Press the key on the A230 for 4 seconds. The red LED double-flashes rapidly and
turns off when the registration has been successful. The LEDs on the C52-SP briefly
turn green and then turn off while the red Power LED turns on.
Pairing with both:
Using
Accepting calls
1. On the phone, select headset mode. NOTE: The C52SP does not ring until headset mode is selected.
2. You can accept a call ringing on the phone on the headset or on the speakerphone, respectively.
• On the A170 headset, press the call button with LED.
• On the C52SP, press
Switching between headset and C52SP while in a call
• From headset to C52SP: Press
• From C52SP to headset: Press the call button with LED on the headset.
One C52 SP and one headset can be registered at the A230.
.
on the C52SP.
Pattern
Steady
Rapid double flashes
OFF
Rapid flashing
Steady
OFF
Steady
Green
Red
-
ON
-
ON
-
-
ON
ON
-
-
-
ON
Advertisement
