Snom A230 Quick Start Manual

A230
USB DECT Dongle
Important Information
Please read the instructions on safety and disposal and on how to set up and use the device before using it
and also give them to other users to read or inform those users of their contents. Save this document and
do not give the device to third parties without it.
Safety Instructions
Follow the instructions in the manual and other applicable documentation of the device.
• Handle the product with care. Crushing, wrenching, or dropping it from even moderate heights may
damage it.
• This device is for indoor use only! Do not install outdoors - NOT FOR OUTDOOR USE!
• Do not install the device in rooms with high humidity (for example, in bathrooms, laundry rooms, damp
basements).
• Do not immerse the device in water and do not spill or pour liquids of any kind onto or into the device.
• Do not expose the product to extreme heat.
Standards Conformance
This device complies with the essential health, safety, and environmental requirements of all relevant
European directives. Unauthorized opening, changing, or modifying the device will cause the warran-
ty to lapse and may also result in the loss of CE conformity. In case of malfunction contact authori-
zed service personnel, your seller, or Snom.
Safety: IEC 60950
Disposal
This device is subject to European Directive 2012/19/EU and may not be disposed of with general
household garbage. If you do not know where you may dispose of the device at the end of its lifespan,
contact your municipality, your local waste management provider, or your seller.
Registering a wireless device (speakerphone, headset)
1. Remove the dongle's protective cap.
2. Insert the dongle into the USB port.
3. Press the key on the dongle for 4 seconds to enter registration mode; the red
LED begins to double-flash rapidly. You now have 10 seconds to register the
device.
4. For pairing with A170/A150 headsets and C52-SP, see reverse side. For pairing
with other wireless devices, please refer to the manuals of the devices.
Deregistering
1. Press the key on the dongle for 10 seconds to enter deregistration mode. After 4 seconds the red LED
starts to double-flash; after 10 seconds the LED starts to flash red rapidly, indicating that the dongle has
entered deregistration mode.
2. Release the key and press it again for 1 second to confirm deregistration. The LED turns green for three
seconds, turns off for one second and then shows steady red light.
© 2019 Snom Technology GmbH. All Rights Reserved.
Snom is a registered trademark of Snom Technology GmbH in the European Union, USA, Japan, China and certain other countries and regions.
Unless specified otherwise, all trademarks, in particular product names, are legally protected trademarks of Snom Technology GmbH. Other
mentioned trademarks or registered trademarks are the property of their respective manufacturers or owners. Product specifications are sub-
ject to change without notice. We do not accept liability for printing errors and mistakes. snom.com
v2019001