Advertisement
FEATURES
•
Reduced energy consumption with automatic snow
melting.
•
Slim design minimizes visual impact.
Mounts on ¾"PVC or ½" PVC with optional reducing
•
bushing or ½" NPT with included fittings.
•
Operates on safe low voltage power.
•
Simple 3 wire connections, 2 power, one signal.
•
Drop in replacement for ETI's CIT-1 aerial sensor
•
Convenient power-on self-test to verify proper sensor
operation
•
Housing made with ASA UV-resistant plastic that was
formulated by the auto industry for exterior plastic trim
•
Made in the USA
INSTALLATION GUIDE & OPERATION MANUAL | PART NO.
25484
REV
B
Advertisement
Table of Contents
Related Manuals for ETI Snow Owl
Summary of Contents for ETI Snow Owl
- Page 1 • Operates on safe low voltage power. • Simple 3 wire connections, 2 power, one signal. • Drop in replacement for ETI’s CIT-1 aerial sensor • Convenient power-on self-test to verify proper sensor operation • Housing made with ASA UV-resistant plastic that was formulated by the auto industry for exterior plastic trim •...
-
Page 2: Specifications
Use a GFEP (Ground Fault Equipment ELECTRICAL SHOCK / FIRE HAZARD Protection) circuit breaker on each branch As a low voltage control the SNOW OWL has a circuit connected to the ice melting system. maximum current load of 2 amps resistive for... -
Page 3: Theory Of Operation
NEC Article 426.28 requires equipment output only when both conditions are present. ground fault protection (GFEP) for ice and This allows the SNOW OWL to trigger a heat snow melting equipment. This functionality is cycle only when it is needed. Once the SNOW... -
Page 4: Installation Diagrams
Once the SNOW OWL has been mounted in the desired location it can be connected to the controller or contactor. POWER ON SELF TEST PRE-INSTALLATION TEST The SNOW OWL performs an internal self test when the power is first turned on. During the first 10 seconds of power up the sensor will... -
Page 5: Testing After Installation
For complete warranty information please visit our web site at: www.networketi.com GF-PRO, PD-PRO, APS-3C, APS-4C, EUR-5A & CIT-1 are trademarks of Environmental Technology Inc. SNOW OWL is a trademark of ETI. INSTALLATION GUIDE & OPERATION MANUAL | PART NO. 25484...
Need help?
Do you have a question about the Snow Owl and is the answer not in the manual?
Questions and answers