Download Print this page

motif CLEAN-Z Quick Manual

Clean-Z Quick Guide

Clean PAP Mask and Tubing

Insert Filter into Bag and connect mask to tubing, and place into

bag. Close bag around tubing using velcro. Attach Clean-Z to end

of tubing. Connector adapter might be needed based on your

PAP equipment.

Clean CPAP Device and Tubing

Connect Clean-Z to CPAP tubing, and then the tubing to the

PAP Device. Connector adapter might be needed based on your

PAP equipment.

Connect power supply to Clean-Z, and plug into electrical outlet.

Press Power button and Clean-Z will start and automatically run

through a complete cleaning cycle.

Insert

Filter

| Assemble Unit

Power

Button

Mask

Inside

Table of Contents

Do you have a question about the CLEAN-Z and is the answer not in the manual?

Page 1 Clean PAP Mask and Tubing Insert Filter into Bag and connect mask to tubing, and place into bag. Close bag around tubing using velcro. Attach Clean-Z to end of tubing. Connector adapter might be needed based on your PAP equipment.
Page 2 Do not dissemble or dismantle the Clean-Z device. Warning: Do not run Clean-Z for more than two consecutive cycles. Warning: Do not use Clean-Z while your PAP machine is in use. Clean-Z is not a PAP Machine. For More Information Visit www.motifclean-z.com...