Table of Contents
Advertisement
2
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2>
1.1. BEFORE INSTALLATION
Check the contents and the number of the accessories in the
packing.
1 Remote Control
2 screws ø4x16L
Switch, for Operation
For fixing the
Control
Holding Bracket
onto the wall
1.2. INSTALLATION SPACE
In case of installing the controllers in vertical line, keep a
distance more than 10 mm between the controllers vertically. If
the distance is insufficient, the front cover of the controller can
not open wide enough
Fig. 1 Installation Space
1.3. INSTALLATION PROCEDURE
1. Insert the edge of the flat head screwdriver into the dent
parts at the bottom of the holding bracket, push and turn
the screwdriver and remove the controller from the holding
bracket as shown in the figure below.
Controller
Holding
Dent
Bracket
part
Screwdriver
Fig. 2 Installation Procedure
1 Remote
1 Ring Core
Control Cable
and
(8 m) for
1 Fixing Band
connection
More Than 10 mm
Bottom view
Dent part
Dent
part
Screwdriver
Holding
Bracket
Fig. 3 Installation Procedure
2. Attach the controller to the holding bracket as follows.
A. In case of exposing Remote Control Cable.
É Fix the holding bracket onto the wall as shown below
Fig. 4 Attach the controller
Ê Make the hole for drawing out the cable
Fig. 5 Drawing out the cable
Holding Bracket
Dent part
Fix the holding bracket with
the mark " ↑ UP" upward
Screw
(Accesory)
Select the position for drawing out the
cable among 3 positions marked with *
and make the knock-out hole by cutting off
with a cutter or so. Two sizes of the line for
the knock-out hole are prepared, and the
inner line is for the cable.
Hide quick links:
Advertisement
Table of Contents
