Watermark WM-BT07 Quick Start Manual

Quick Start Guide Bluetooth Music Receiver WM-BT07
Compatible with the following models:

AUDI: CQ-JV1060L, RNS-E (16:9), BNS 5.0, Chorus 3, Concert 3, Symphony 3

VW: MCD, MFD2-RNS 2, MFD2 DVD-RNS2 DVD, R110, R100, RNS 300, RNS 500, RNS
510, RCD 200, RCD 210, RCD 300, RCD 310, RCD 500, RCD 510, Delta 6

SKODA: Nexus (16:9), Columbus, Stream, Cruise, Rhapsody

SEAT: Navigation (16:9), Audiosystem CD03, Altea CD01, Altea CD02
Connect the Adapter:
1. Remove the radio.
2. Before disconnecting the plugs from the radio, make sure that the radio code is
available to you as you will need it for the radio after the power cut.
3. The plug of the Bluetooth Adapter WM-BT07 must now be inserted from the back of
the Quadlock connector into chamber B until it clicks into place. This should also go
if the Quadlock plug is still on the radio (radio before plugging but off). If the cables
are short or you can see bad the back of the plug, you can also completely
disconnect the Quadlock plug from the radio.
4. Now connect the black ground cable with the eyelet either to the radio housing or
the black cable directly to a ground line to the Quadlock plug.
Without a good ground connection, the function of the adapter is not given.
5. Establish a Bluetooth connection by activating Bluetooth pairing and searching for
the `` WM` 'Bluetooth device. You should then set the volume to full volume on the
connected device.
6. Before reinstalling the radio, test the function of the adapter. Switch on the AUX
function with the CD changer button.
Has something been left unclear? You can reach us MO-FR, from 8-17 o'clock under the E-Mail:
service@watermark-germany.de
REV.:001 11/2017FF