Address Resistor; Adjustment Of Address Resistor; Phase Active Leds - Flex BMR 481 P1E+ User Manual

5

Address Resistor

5.1

Adjustment of address resistor

6

Phase Active LEDs

These LEDs (position 19) indicate the number of phases currently being used.
Each LED will light up when the corresponding MAIN or SATELLITE is switching,
i.e. when there is an active PWM signal.
MAIN = Phase 1. SATELLITEs = Phase 2-6.
287 01-ROA 170 014 Rev A
To change the address, change the resistor shown in Figure 2.
Figure 2 Address resistor position, R6, is shown in the picture.
Change resistors R6 (SA) to achieve the desired PMBus address for
the MAIN module.
2018-10-16
Reference Board BMR 481 P1E+
R6
9 (12)