Labgear LDU608G Quick Start Manual

Download this manual

Enlarged version

How to fit an F-type connector

Using a sharp knife carefully remove 20mm of the outer

plastic of the cable, ensuring not to cut the shield

braiding below. Take half the braiding to each side and

twist, creating two tails.

Remove the metal foil to expose the insulator below.

With your knife trim the insulator to about 2-3mm from

the base of the exposed cable, ensuring not to cut the

inner cable.

Ensure that none of the braids from the outer tails are

loose. Pull the tails down and twist them round the

outer insulator in a 'helter-skelter' formation.

Twist the connector down so it bites onto the braiding

and outer insulator. Check that there is no connection

between the inner core and braiding and tighten until

the inner insulator is in line with the inside hole

Trim any excess braiding with a sharp knife and tightly

wrap round the edge with electrical insulation tape. For

outdoor use (ie satellite dish/masthead amp) it is

recommended that you dip the connector into

Vaseline/silicon grease for waterproofing.

Labgear TV Distribution System

LDU608G/LDU604G

www.cyberselect.co.uk

01603 789840

Page 1 Labgear TV Distribution System How to fit an F-type connector LDU608G/LDU604G Using a sharp knife carefully remove 20mm of the outer plastic of the cable, ensuring not to cut the shield braiding below. Take half the braiding to each side and twist, creating two tails.
Page 2 In your remote rooms you can control your tvLink Receiver centrally located equipment over the coaxial cable using the Global tvLINK (Sky only) or the Labgear HandyLink (all conventional IR devices). HandyLink Receiver The HandyLink box goes at your main location and is the last item before you connect back to the Up-Link (as Page 1).
Page 3 Configuration for two-four Sky, Sky+ or Sky HD decoders When you intend to have two (or more) main locations for Sky, Sky+ or Sky HD decoders you need to run a total of four satellite grade CT100 aerial cables to each main location. You will be able to control up to four Sky, Sky+ or Sky HD decoders using the tvLINKS and Global Super Plus Combiner.

Ldu604g