Makita XLS01 Instruction Manual page 10

You can remove the dust collection brush for operation
along the edge of wall or ceiling. The removed brush
can be attached to the sanding head as shown in the
figure.
► 1. Dust collection brush 2. Sanding head
Hex wrench storage
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
2
1
Installing or removing the pad
► 1. Hex wrench 2. Bolt 3. Pad
To remove the pad, remove the abrasive disc from the
pad, and then turn the bolt counterclockwise with a hex
wrench. To install the pad, perform the removal proce-
dure in reverse.
CAUTION:
Make sure that the pad is secured
properly. Loose attachment will run out of balance
and cause an excessive vibration which may cause
loss of control.
Connecting a vacuum cleaner
Optional accessory
When you wish to perform operation cleanly, connect a
Makita vacuum cleaner to your tool. Connect a hose of
the vacuum cleaner to the dust nozzle using the front
cuff 24.
► 1. Hose of the vacuum cleaner 2. Front cuff 24
3. Dust nozzle
10 ENGLISH
1
2
3
1 2
3