Advertisement
Active needed video inputs like following:
- CAM: DIP switch 5 down
- AV1: DIP switch 2 down
- AV2: DIP switch 3 down
* DIP switch 1,4,6,7,8 must set up (not used).
Camera / Video inputs:
When interface is not reacting by CANbus, reverse wire (green) should be connected with an
analog (12V) reverse signal. It's also possible to connect the other power signals without
CANbox, analog as below:
Yellow + red: +12V acc.
Black:
ground
Green:
+12V reverse
White:
optional (+12V, switch from OEM to AV1 / AV2)
Grey:
n.c.
Interface menu settings:
Installer may use the 3 keys MENU, DOWN, UP on the ( bottom or side)
interface box to change external (camera) image settings if needed.
12
Advertisement
