Page 6
Unlock the LCD ribbon cable very carefully Avoid damage and do not use any solid tools! ...
Page 7
Connect the switchboard as shown below Be careful with the ribbon cables! ...
Page 8
Connect the original LCD ribbon cable with the right cable of the switchboard ...
Page 9
Fix the switchboard on the LCD housing as shown below ...
Page 10
Fix the plastic cover back on LCD housing...
Page 11
Connect the power cable in between and the interface as shown below...
Page 12
Active needed video inputs like following: - CAM: DIP switch 5 down - AV1: DIP switch 2 down - AV2: DIP switch 3 down * DIP switch 1,4,6,7,8 must set up (not used). Camera / Video inputs: When interface is not reacting by CANbus, reverse wire (green) should be connected with an analog (12V) reverse signal.