Page 2
DeskView is installed. PRESS: GRIP: STEP 3 STEP 2 Check to see DeskView is level, then Grip the brackets with your thumbs press firmly against the clean, flat on the inside, fingers on the outside, glass surface (see “Testing Non-Glass and levers resting against your palm.
Page 3
Pull Away from the glass to ensure secure suction. Re-test in 5 minutes and then every 12 hours. If the required suction force has not been achieved, repeat steps 1-4 before using your DeskView. WARNING: Changes in temperature and impurities in the surface can weaken the suction force over time.
Page 4
Installation Steps 1-5 on pages 1 - 2 at the desired height. WARNING: Ensure the non-glass surface is rated to withstand the weight you will be placing on DeskView. Do not use DeskView on any surface that fails Step B. *DeskView DOES NOT adhere to drywall, cement, and PAGE | 03...
Page 5
WARNING: The levers can release at high-speed. Avoid injury and damage to your DeskView by keeping your palms on the lever as you release with your middle two fingers. DO NOT place your thumb on the lever at any time.
Page 6
DO NOT remove the top surface or try to replace the rubber suction discs or any other components without first receiving proper replacement instructions from us by contacting contact@shop- deskview.com *Deskview offers FREE REPLACEMENT for damaged rubber suction discs. https://DeskView.co...
Page 7
Contents subject to revision without prior notice. DeskView is a registered trademark of Abvious, LLC (the “Company”). All rights reserved. No part of this manual may be reproduced, transmitted, transcribed, or translated into any language, in any form or by any means, without the prior written consent of the Company.
Need help?
Do you have a question about the Lightweight standing desk and is the answer not in the manual?
Questions and answers