Advertisement
Part 4 -- Display Installation
Step 1: On the tailstock end and back side of the machine, hold the display mount bracket and
mark the top two holes that need to be drilled using a sharpee. (Depending on how new your
GraniteXT machine is, you may not need to do this step or the following steps to drill holes –
they might already be drilled.)
Step 2: Once the holes are marked, punch to center punch the holes. Drill and tap the holes to
8mm. Assemble the display arm.
Step 3: Assemble the display brackets and pins, as pictured below.
Step 4: Mount the display arm and extension arm, as pictured below.
Advertisement
