Part 1 -- Z-Axis Installation - Smithy GRANITE XT SINO DRO Installation Instructions Manual

Part 1 -- Z-Axis Installation

Step 1: Start by installing the Z-Axis quill bracket. Use one of the longer 5mm screws and screw
it in the end of the bracket. When installing the bracket on the millhead, the flat on the front of
the bracket with the 2 screw holes needs to be parallel with the flat spot on the mill head.
One of the
Front of
longer 5mm
Bracket with 2
screws
Screw Holes
Step 2: Mount the square bracket to the angle bracket using two more 4mm screws.
Step 3: Install the angle bracket onto the front of the mill head using two 4 mm screws. Screw
them into the 4mm holes already drilled in the millhead.
Step 4: Install the Z-Axis Encoder Bracket using two more 4mm screws that are 10mm long (they
are shorter than the others). Screw them into the end of the already-installed Quill Bracket.
When installed vertically, the Z-Axis Encoder Bracket should look like this.