Download Print this page

American Standard 9118.111 Installation Instructions Manual

Icu sink system

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS
ICU Sink System
Models: 9118.111, 9118.100 & 9118.150
Introduction: Thank you for selecting our products...products which have been the
benchmarks of fine quality for years. To help insure that the installation process will
proceed smoothly, please read these instructions carefully before you begin. Also,
review the recommended tools and materials list; carefully unpack and examine your
new plumbing fixture.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID DAMAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
Recommended Tools & Materials
Pipe Wrench
Level
Channel Lock Pliers
Rough-In
Dimensions
14-3/4"
(375mm)
40-1/8"
(1020mm)
26-1/8"
(663mm)
*DISCLAIMER: Faucets with a base diameter greater than 2-1/4" (57 mm) will not fit on this
ICU Sink. The Selectronic ICU Faucet was specifically designed to minimize splashing during
operation. American Standard will not be liable for any splashing that occurs if faucets other
than the American Standard ICU Faucets are used.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 1 2
Adjustable Wrench
Drill
20"
(509mm)
4-3/4"
(121mm)
17"
(432mm)
5/8"
(14mm)
8"(203mm) BETWEEN
MOUNTING HOLES
*
FAUCET PERCH
2-1/2" DIA. (65mm)
36-1/2"
(927mm)
36"
(914mm)
Plumbers' Putty or Caulking
Tubing Cutter
Phillips Screwdriver
*
FAUCET PERCH
2-1/2" DIA. (65mm)
36-1/2"
(927mm)
9/16" DIA.
2-3/4"
(14mm)
(70mm)
2-3/4"
(70mm)
4"
4"
(102mm)
(102mm)
1
Tape
Measure
Torch
Regular Screwdriver
1-5/8"
(41mm)
RECOMMENDED CARRIERS:
JAY R. SMITH MFG. CO.
MODEL SQ-0-4437
FLOOR MOUNTED SINK SUPPORT
WATTS CA-311
FLOOR MOUNTED URINAL CARRIER
Hacksaw
Pencil
7301793-100 Rev. C

Advertisement

loading

Summary of Contents for American Standard 9118.111

  • Page 1 ICU Sink. The Selectronic ICU Faucet was specifically designed to minimize splashing during FLOOR MOUNTED URINAL CARRIER operation. American Standard will not be liable for any splashing that occurs if faucets other than the American Standard ICU Faucets are used.
  • Page 2: Install Faucet

    ROUGH-IN SUPPLIES AND WASTE OUTLET INSTALL FAUCET NOTE: For more detailed information, see the installation 1. Rough-in 3/8" supplies and waste outlet connections. instructions supplied with the ICU FAUCET. #(M965119) NOTE: For ease of installation and accessibility, it is 1. Insert WIRES (1), FLEX HOSE (2) and SPOUT SHANK (3) recommended that straight stops with flex supply tubes be through center hole of mounting surface.
  • Page 3 INSTALL ICU SINK INSTALL ELECTRONICS HANGER BRACKET 1. Mount SINK onto the two HANGER STUDS. Hold SINK in place 1. Install the ELECTRONICS HANGER BRACKET onto remaining and temporarily install NYLOCK NUT & WASHER on one of the HANGER STUD. Install NYLOCK NUT & WASHER but do not HANGER STUDS to retain SINK.
  • Page 4 ENCLOSURE (3) base. NOTE TO INSTALLER: Please give this manual to the customer after installation. To learn more about American Standard Faucets visit our website at: www.us.amstd.com or U.S. customer's e-mail us at: faucetsupport@amstd.com Note: If additional supply length is required, installer must...
  • Page 5 M 9 6 5 119 NOTE TO INSTALLER: Please give this manual to the customer after installation. To learn more about American Standard Faucets visit our website at: www.us.amstd.com or U.S. customer's e-mail us at: faucetsupport@amstd.com For Parts, Service, Warranty or other Assistance,...
  • Page 6 INSTALL SINK APRON 3. Remove the APRON. Clean the wall where the APRON BRACKETS supplied with SINK are to be applied. Peel off the 1. Hold APRON up against SINK and flush against finished wall. protective strip from the back of the APRON BRACKETS. Apply the two APRON BRACKETS to the finished wall parallel to the pencil 2.
  • Page 7 This limited warranty is void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other damages; if it was not installed in accordance with American Standard's instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.

This manual is also suitable for:

9118.1009118.150