Advertisement
Net-Net® 2610/2620 Quick Installation (cont.)
6
Follow the steps covered in the USB Creation and Commissioning
Follow the steps covered in the USB Creation and Commissioning
Instructions for information on creating a USB stick from the Acme Packet
Instructions for information on creating a USB stick from the Acme Packet
s
Net-Net OS-E software download. Included with the software download
Net-Net OS-E software download. Included with the software download
in PDF format, you will need these instructions to commission the system.
in PDF format, you will need these instructions to commission the system.
Remove the front bezel (if installed), insert the USB stick that you created,
then turn on the system power. Check system LEDs.
2. Press power button.
1. Insert USB stick
DO NOT remove the USB stick until the system has
Warning:
completed the bootup sequence, which may take up to ten minutes.
See the System Installation and Commissioning Guide for LED information.
Replace the bezel and secure with the supplied locking key,
if desired.
Acme Packet, Inc.
71 Third Avenue
Burlington, MA 01803 USA
t 781-328-4400
f 781-425-5077
http://www.acmepacket.com
Last Updated: November 2009
Document Number: 400-1003-36
Start the CLI and run the setup script to enable and configure the management interface, establish
7
an IP route (if setting up remotely), enable Web management access, and customize the CLI prompt. Every
Net-Net 2000 Series system has a minimum of two Ethernet interfaces.
Any Ethernet interface can be used for management traffic. However, Acme Packet recommends the
use of eth1, as eth0 is reserved for fault-tolerant clustering with other Net-Net 2000 Series platforms.
Management traffic is also supported on any interface that is carrying private or public network traffic.
This means that it would be possible to use eth1 to carry SIP traffic and management traffic.
NN-OS-E> config setup
set box\hostname: local
config box\interface: eth1
set box\interface eth1\ip a\ip-address: <ipAddress/mask>
config box\interface eth1\ip a\ssh (y or n)? y
config box\interface eth1\ip a\web (y or n)? y
config box\interface eth1\ip a\routing\route: <routeName>
set box\interface eth1\ip a\routing\route <routeName>\gateway:
<ipAddress>
set box\cli\prompt: NN-OS-E 2620>
Do you want to commit this setup script (y or n) y
Do you want to update the startup configuration (y or n)? y
NN-OS-E 2620>
Configure the Net-Net OS-E software, SIP servers and phones,
8
sessions and policies.
Refer to the following Net-Net OS-E documents, available as
downloads in PDF format:
Release Notes
USB Creation and Commissioning Instructions
System Installation and Commissioning Guide
Using the Net-Net OS-E Management Tools
System Administration Guide
Session Services Configuration Guide
Objects and Properties Reference
Network Interface Card Installation
System Operations and Troubleshooting
Proprietary & Confidential
NN2600
Net-Net 2610/2620 Quick Installation
2009 Acme Packet, Inc.
All rights reserved
Advertisement
