Advertisement
Modem
Before using the product, read carefully the following recommendations:
✔ Do not power supply the radio modem with 110 or 120V (recommended voltage: 10 to 30Vdc).
✔ For your safety, the power supply connection to the radio modem must be realized off voltage. Check that the
module power supply is off before all operations.
✔ Do not use without antenna!
Type
Mode
Modbus
Modbus
Modbus
Modbus
Notice technique complète sur
FRQIG_ARM-IOD-LP
Page1/4
Address
Mirror
Mirror
Mirror
Mirror
www.atim.com
Radio channel
Advertisement
Table of Contents
Related Manuals for ATIM ARM-IOD-LP
Summary of Contents for ATIM ARM-IOD-LP
- Page 1 ✔ For your safety, the power supply connection to the radio modem must be realized off voltage. Check that the module power supply is off before all operations. ✔ Do not use without antenna! Notice technique complète sur www.atim.com FRQIG_ARM-IOD-LP Page1/4...
- Page 2 - Modbus slave an ARM-D or an ARM-X. Then the radio module can - Reading logic input - Sensor mode(datalogging) centralize the values from several distant ARM-IOD-LP. - Reading/writing memorized input See the use manual for functioning - Reading voltage power supply...
- Page 3 25mW <1km 868,375 868,475 D (13) 869,475 25mW <1km F (15) 869,575 3. Technical characteristics ARM-IOD-LP Characteristics Interface 2 digital inputs Negative logical Logical input Max frequency counting: 100Hz “Wake-up” delay : 1,55 Delay Answer delay : 3,55 Operating modes...
- Page 4 – Run down the remaining voltage in shorting circuit the + and the - of the battery connector – Configure the slave ARM-D Modem or slave ARM-X mirror mode. Local address=ARM-IO-LP. Destination address= ARM-IOD-LP – Take off the STRAP 2 (OFF) –...
Need help?
Do you have a question about the ARM-IOD-LP and is the answer not in the manual?
Questions and answers