Advertisement
Operation
The 12 series controller consists of 7 buttons with 5 features, and 6 indicator windows. When a feature button is selected, the corresponding
clear indicator(s) will illuminate. Pressing any of the 5 feature buttons will turn that corresponding feature on, pressing it again will turn it off.
There are two large flash pattern preset buttons; only one can be selected at a time. If one is on while the other is selected, it will shut the
previous one off. The "OFF and "SEL" buttons do not have illuminated indicators.
"OFF" - Turns the whole bar off. This is a quick way to shut everything down. Features can also be shut down individually by
pushing the feature's button.
"Power 1, Power 2" - Turns on the flashing modules with whatever flash pattern was stored to this button.
"AL" - Turns on left alley light, or as custom configured.
"WL" - Turns on center pair of takedown or worklights, or as custom configured.
"AR" - Turns on right alley light, or as custom configured.
"SEL" - Advances to the next flash pattern whenever either power button is selected.
Control Pad Mounting:
To mount the control pad with Velcro, separate the two circu-
lar halves, remove the backing and adhere one piece on the
vehicle dashboard and adhere the other to the back of the con-
troller. To mount the control pad using the swivel mount, first
mount the swivel unit to the dashboard with either the supplied
screws (note, the suction cup will not work after drilling screws
through the swivel base) or by turning the lever at the base of
the swivel unit to engage the suction cup. Push the controller
onto swivel slide and press the control pad down onto the slide
until it engages the slot in the control pad. (You may need to
turn the controller clockwise once engaged with the slide to
tighten it.) Turn the dial on the swivel head to tighten it against
the back of the control pad. Finally, loosen the hand screw on
the swivel neck to adjust the angle of the control pad. Hold the
pad in the desired position while tightening the hand screw on
the swivel neck.
920-0335-00 Rev. A
Controller Keypad (EZ0006)
The optional in-cab controller provides convenient control of the Lightbar's 25
built-in flash patterns and features soft touch buttons and LED function indicator
lights. The EZ0006 Keypad controller is designed for easy installation. Simply
unplug the adapter from the control cable and plug in the controller.
Push the controller onto swivel slide and press
the control pad down onto the slide until it
engages the slot in the control pad.
Page 2 of 3
Advertisement
