Advertisement
PA-10 2A3 6W Monoblock Amplifier
4
Operation
The PA-10 operates like any other power amplifier, connected between your
linestage and speaker. For stereo operation, two PA-10s are required.
Connect the power cord to a 120Vac source. Turn on using the pushbutton power
switch on the back panel. The PA-10 requires about 30 seconds warm-up to start
playing, and another 30 minutes to sound its best, which is typical of high quality
tube equipment.
There are output taps for either 4 ohm or 8 ohm loads.
Advertisement
