Operation - FERREX PGG40G User Manual

AUS

Operation

1. Switching on/off (see fig. B)
To put into operation
1) Insert the power plug into the mains
power supply, and turn the power switch
on.
2) Place the gun on the support stand /
rest (6). Allow the gun to heat up for
approximately 3 min before beginning
work.
To switch off, turn off the mains power switch and pull the mains
plug out.
WARNING: Allow the unit to cool completely before
storing. The hot nozzle can cause damage.
NOTE: As the result of heat storage, the glue gun can also be used
after it has heated up without being connected to the mains. If
the glue that emerges becomes thick, insert the plug into the mains
power supply again.
WARNING: Disconnect the glue gun from the mains
power supply when not in use.
2. Gluing
Preparations for Gluing
The surfaces to be glued must be clean, dry and free of grease. A
smoother surface is also more ideal for gluing.
WARNING: Do not use inflammable solvents for
cleaning!
The ambient temperature and the work piece to be glued must not
be cooler than +5 °C or warmer than +50 °C.
Warm rapidly cooling materials (e.g. steel) for better adhesion.
8
e-mail: info.aldi@positecgroup.com
MODEL No.: PGG40G • 05/2020 • 701256
B
AFTER SALES SUPPORT
1300 889 028
AUS
(toll free)
Glue Gun