Tie Down System Maintenance Operation Controller Settings Power down when not in use Reaching or Lean Cornering Information Obstacles Curbs, Ramps, Slopes & Sidehills Environment & Everyday Use Controller Braking System Armrests Free Wheel Mode JDY Imports 323-522-5817 Page 1...
Page 3
Setting up your Move Lite Unboxing the Move Lite Lock Latch Free Wheel Mode Installing the Controller Batteries & Charging Charging Charging Tips & Notes Operation and Installation Controller Controller & Driving Tips Batteries Seat Design & Materials Fasteners Change & Adjustments...
Introduction Thank you and congratulations on the purchase of your new Move Lite Foldable Power Chair. It is important that you read through this manual before operating your chair - so, please take that time. You will find instructions and recommendations for easy operation of your Move Lite Power Chair.
● Practice bending, reaching and transferring in and out of the Move Lite. ● Always be aware of your surroundings. ● ake it easy. If you’re not sure the Move Lite and surpass an obstacle, try to find another way around.
The Move LIte is not approved to be used with any tie down system, generally used to transport a seated user and power chair in a motor vehicle. ● Never sit in the Move Lite while in a moving vehicle. In an accident or sudden stop you may be thrown from the Power Chair.
● Move yourself as close as you can to the object you wish to reach ● Turn off all power to the Move Lite before reaching ● Firmly grasp an armrest with one hand. This will help to prevent a fall if the Move Lite tips Cornering Information Always slow down while moving through a corner.
Move Lite to tip forward ● Be mindful of any side hills as tipping is an issue ● Your Move Lite is not designed to drive up or down a curb or step more than 1/2 inch high ○...
Move Lite. To engage free wheel mode, push up on the two red levers - one next to each wheel. See Free Wheel Mode below, in the ‘Setting up your Move Lite’ section for pictures.
Page 11
#4. Main unit which includes the seat and motor assembly #5. Controller #6. Batteries* *Note: Most Move Lites ship with the batteries installed. However, some Move Lites will ship in two boxes: main unit/controller (4 & 5) and batteries (6). JDY Imports 323-522-5817 Page 10...
Page 12
#7. Grab the padding as indicated and pull straight up. #7. Here’s an image of the Move Lite midway through opening. It’s super easy. JDY Imports 323-522-5817 Page 11...
Below you’ll see the ‘lock latch’ connector, which is located under the seat; it’s made up of two parts: (1) clip and (2) lever. Please use caution when closing the Move Lite, as the lock latch could get caught in the wrong position and break. Push the lock latch flat and out of the way.
Here the Lock Latch closed. #1. The clip in the closed. #2. Lever To close, position the clip over the small bar then push the lever down Important: Only operate the Move Lite while lock latch is closed. Free Wheel Mode JDY Imports 323-522-5817...
Installing the Controller The main unit comes ready to receive the controller for a right-handed user. With a little rearranging, the Move Lite can be setup for a left-handed user as well. #1. From the factory setup for right handed users.
Page 16
Slide the controller into the open slot as shown. #3. Tighten the knob to secure the controller in place. JDY Imports 323-522-5817 Page 15...
#5 - together. Once connected, secure the two wires by tighten the with the plastic coupling ring on #4. Here is a view of the connected controller. #6. Coupling ring. Batteries & Charging Charging JDY Imports 323-522-5817 Page 16...
Page 18
#2. Power supply brick #3. Plug adapter ***Preferred Charging Method*** Attach all three cords together (#1, #2 & #3), and insert into #4. This method allows you to charge both batteries at the same time. JDY Imports 323-522-5817 Page 17...
● Do not charge more than 6 hours to 8 hours. ● If you do not operate the Move Lite for two months, we recommend that you charge the battery for 6-8 hours before use.
● If you use the Move Lite daily, check the battery light indicator to see how much charge you have left. The Move Lite is equipped with two (2) lithium batteries and will go up to ~7 miles per battery, for a total of ~15 mile.
Page 21
#2. Power check read-out. Lights correspond to how much power is available in these batteries. #3. Charging input. Note: You can charge your Move Lite here. Also, you can both batteries via a connector under the controller. The Move Lite requires batteries on both sides.
Page 22
Here’s a view of the bottom of the battery. Molded into the plastic is the +/- sign. Again, make sure to gently insert the battery. It should slide easily into place. Smoothly insert the batteries as shown. JDY Imports 323-522-5817 Page 21...
#3. Speed Control Buttons - two buttons (plus & minus) allow the user to control max speed #4. Speed Indication Lights - five lights indication relative max speed #5. Battery Power Indication Lights - shows user how much power is available #6. Joystick - controls speed and direction of the chair JDY Imports 323-522-5817 Page 22...
● To stop, just bring the joystick back to the initial position ● Getting into the Move Lite ○ Before sitting, make sure the Move Lite is p owered off , this will ensure the Move Lite will not move upon touching the joystick ○...
● Use extra care when you drive the Move Lite in reverse. You may lose control or fall if one of the rear wheels hits an object. ○ Operate the Move Lite slowly and at an even speed. ○ Stop often and check to make sure your path is clear of obstacles.
3. Over or under-tightened fasteners may fail or cause damage to the Move Lite parts Change & Adjustments Never use non-Move Lite parts or make changes to your Move Lite unless authorized in writing by a representative from our company. Doing so will void the Warranty and may create a safety hazard.