Fisher & Paykel DCS GDE1 Installation Manual page 15

Designed with flexibility in mind, the 30" griddle can be either built-in or mounted on a
freestanding cart. If the unit is to be placed onto a freestanding cart, an approved DCS
cart is required and can be purchased separately from your local DCS dealer.
CAD1-30 freestanding cart part number: 71432
Preparing the griddle
support bracket
1
(remove on
both sides)
cart bracket
2
(secure on
both sides)
FREESTANDING CART INSTALLATION (OPTIONAL)
IMPORTANT!
For further guidance, refer to the installation
z
guide provided with your freestanding cart.
Wear gloves when handling the cart, some
z
edges may be sharp.
Two or more people are required to move
z
and assemble the cart.
Push or pull the cart at the corners, do not
z
move by the drawers or handles.
To prevent tipping, do not push down on top
z
of the drawers.
For optimal use, this product should be
z
located on a level surface with minimum flat
area of 30x48" (762 x 1219mm). Any bumps,
cracks or protrusions should be less than 1/4".
Do not overload the drawers. The maximum
z
rating of each drawer is 35lbs.
Remove the support brackets from
the sides of the unit and replace with
the supplied cart mount brackets.
Secure cart mounting brackets
using four of the supplied 10-24 x
1/2" screws on each side.
Securing griddle to cart
1
2
3
Remove the drip pan and any other
removable components from the
griddle.
cart bracket
fixed to side
of griddle
Place the griddle on the cart by
locating the rear side tabs of the unit
with the slots on the cart. Lower the
griddle and locate the remaining tabs.
The griddle should sit flush on the
cart.
Secure the griddle to the cart with
two Phillips-head screws at the rear
and three at the front.
Replace any components removed
in step 1 before referring to page 9
for gas connection advice.
13