Eneo VHM/H24W Mounting Instructions page 7

3. Heaters
3.1 Assembling the VHM/H24W heating kit
A
S
F, A
Front panel, Middle
section of housing
H Heater circuit
board
f, r
Screws,
separating bolts
S
Cable duct
r
f
Unscrew the front section F (with the glass pane) off the middle section
of the housing A.
Screw the heater circuit board H onto the front section F.
The resistances must display on glass insert.
Use the screws f and the separating bolts r (8mm) from the enclosed
package according to the diagram.
Bring the heater circuit board's power connection through the cable duct
S to the connection circuit board on the back of the housing and connect.
F
r
H