Maintenance And Cleaning P12 - Zanussi ZHT800X Operating Instruction

Maintenance and Cleaning
1. Always disconnect from power supply before
cleaning.
2. Clean both exterior and interior of the hood
long lasting.
3. Fan safety grill can be detached for cleaning
by removing the screws with a screwdriver.
lt must be reinstalled after cleaned.
4. Oil dish on the grill can also be detached for
cleaning by turning the dish anti-clockwise.
5. The oil cup in the centre of the hood for holding
grease can be detached and cleaned regularly.
6. Make a habit to turn on the hood before using
stove to avoid high heat in the kitchen.
7. The two easy dismantle rotary knobs are set
bottom panel, please turn them anti-clockwise
to " - " then loosen safety screw to dismount the
bottom panel. It is easy to clean and repair.
To turn easy dismantle rotary knobs to " ∣ " and
fasten the safety screw to set bottom panel back.
8. Please must disconnect power before installing
light bulb. To refer Item 7 to dismount bottom
panel and then fasten/loosen light bulb with
socket.
Note：Only replace no more than 4W LED bulb
for ZHT800X and ZHT850X. And light bulb
MUST be equipped with international
safety mark.
Please contact distributors for the LED
strip for ZHT900X.
12
Remove
Assembly
Clockwise to install
Anti-clockwise to detach
Easy dismantle rotary knobs
Safety screw