Safety Information - OPTOKON OFT-920 User Manual

6 Safety information

This equipment complies with the following safety classifications:
IEC825-1 and 21CFR1040: Class1
This applies to laser and LED options up to 1 mW, above 700 nm. Devices in this
category are classified as safe for use by technicians under normal viewing, as long
as magnifying devices are not used.
It is the responsibility of the user to gain adequate training and familiarity
with the relevant safety issues and work practices before using this
equipment.
• Never use magnifying devices to inspect optical fiber ends unless you are sure
that no optical power is being emitted.
• Use only magnifying devices with a built-in infra-red filter to ensure safety.
• During operation, testing or maintenance of a fiber optic system, never look
into an active fiber optic cable. Infrared radiation may be present and
permanent eye damage can result.
• Avoid direct exposure to the beam.
• Do not activate the laser when there is no fiber attached to the optical output
connector
Under no circumstances should you look into the end of an optical cable attached to
the optical output when the device is operational. The laser radiation can seriously
damage your eyesight.
WARNING!
- 8 -
OFT-920 USER MANUAL