Page 1
OWNERS MANUAL AQUACUBE RV Part No. COMP827 WARNING OUTDOOR USE ONLY ® AUSTRALIA ONLY SAI Global GAS SAFETY Cert. SAI - 400097 CERTIFICATION AS 2658 - 2008 OWNERS MANUAL Australia’s original Outdoor brand...
IMPORTANT: Read these instructions for use carefully. Familiarise yourself with the appliance before connecting it to a gas container. Keep these instructions for future reference. GENERAL WARNINGS • This appliance shall only be connected to a cylinder with a POL cylinder valve certified to AS2469 standards.
• NEVER check for leaks with a flame or pilot light. • Using Companion Gas Leak Detection Spray or soapy water, coat all connections, if bubbles appear turn the cylinder gas control off and retighten the connection before re-testing.
SAFETY INSTRUCTIONS This appliance shall only be used in an above ground open air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with one of the following: (A) An enclosure with walls on all sides, but with no overhead cover.
OWNERS MANUAL CARBON MONOXIDE HAZARD USING THIS APPLIANCE IN AN ENCLOSED SPACE MAY CAUSE DEATH. DO NOT USE IN CARAVANS, TENTS, MARINE CRAFT, CARS, MOBILE HOMES OR SIMILAR LOCATIONS. IMPORTANT – This appliance is designed to be used with a source water temperature of 20ºC or below, if the temperature of the outlet water exceeds 45-50ºC the burners will shut off and will only relight once the outlet water temperature falls below 45ºC.
Page 6
APPLIANCE INCLUDES CARRY HANDLE BURNER VIEW WINDOW MODE CONTROL GAS CONTROL WATER CONTROL LCD DISPLAY POWER SWITCH 2 x D BATTERIES* GAS INLET (NOT INCLUDED) WATER OUTLET WATER INLET GAS HOSE *D batteries to power electronic ignition & REGULATOR SHOWER HEAD &...
Page 7
Step 8. Turn the gas cylinder on in an anti-clockwise direction one (1) full turn, then check connections for leaks with Companion Gas Leak Detector or soapy water (do not use a flame). If a leak is detected turn the cylinder valve off, allow any residual gas to disperse, retighten all connections then retest.
The temperature of the water can be increased or decreased by adjusting either the gas & water flow controls to achieve the desired water temperature. When being used in colder climates or the inlet water temperature is below +10 degrees select the “Winter” mode to increase the burner performance. The water flow can be stopped at any time by sliding the flow switch on the shower head to the “OFF”...
OWNERS MANUAL ADJUSTING WATER TEMPERATURE Step 1. To increase water temperature turn GAS control to MEDIUM / HIGH & allow temperature to stabilise Step 2. Adjust the water flow to achieve the desired water temperature If ideal temperature is not achieved in SUMMER MODE the following steps can be followed with the appliance operating: Step 1.
PACKING THE APPLIANCE Step 1. Disconnect the power and gas supply to the appliance. Step 2. Disconnect the pump and shower head checking the flow switch is in the “ON” position, hold the hoses vertically until all the water has been drained. Step 3.
OWNERS MANUAL TROUBLE SHOOTING GUIDE DO NOT ATTEMPT TO REPAIR OR MODIFY THE APPLIANCE The guide should be followed in case of failure of the appliance to operate correctly. If symptoms persist contact Customer Service on 1300 555 197 ERROR CODES or enquiries@companionbrands.com.au, The appliance is fitted with operational &...
Page 12
Distributed by Companion Brands Bundoora Victoria 3083 www.companionbrands.com.au...
Need help?
Do you have a question about the AQUACUBE RV and is the answer not in the manual?
Questions and answers