Advertisement
IMPORTANT - READ ALL INSTRUCTIONS BEFORE ASSEMBLING EASEL and USE 2 PEOPLE WHEN ASSEMBLING!
STEP 1. Attach the [4] castors to
the two base feet (1) making sure
the 2 locking castors are
positioned in the rear. NOTE:
the rear of the base has the hole
nearest that castor position.
Secure with four screws (B)
per castor.
See FIG 1.
Rear of the base
with hole.
STEP 2. Attach the two Base Cross members (2) to the
base feet (1) By inserting the oval male end of the Base
Cross member into the oval female cut-out of the base
foot. See Fig 2. NOTE: The hole in the cross member
should be up, since the base is upside down.
Repeat with
second cross
member.
FIG 2
2
STEP 3. Secure Base Cross Members to base using
the four 6 X 60mm Bolts and Cams (A). Insert Cam into
hole found in Base Cross Member and insert bolt into
base foot. Tighten by holding Cam in position while
tightening down bolt with phillips screwdriver. See FIG 3.
FIG 3
2
1
1
1
Screwdriver
Cam
STEP 4. Turn your base assmebly over onto the
castors and you should now have a base that is
assembled like FIG 4.
FIG 1
STEP 5. This next step involves attaching the uprights
(3) to the base assembly. You will find two oval holes on
the top side of the assembled base, these oval holes
are for the oval male ends of the uprights (3) to go into.
Secure with two 6 x 60mm bolts and cams (C).
Phillips
FIG 5
2
1
2
3
1
3
2
2
1
1
FIG 4
Insert Cam
here and
t
g i
h
e t
n
b
l o
f t
o r
m
bottom of Base
with phillips
screwdriver
6 X 600 mm
bolt here
3
After proper
assembly, base
with uprights
should look like
this.
1
Page 2
Advertisement
