CTC Union PowerStation P7 Series Replacement Manual

Backlight bulb replacement

P 7 B a c k l i g h t B u l b R e p l a c e m e n t

Background

Computer Technology Corporation

This document describes the procedures required to replace the backlight

bulbs (model number BLR-6070) in the P7 TFT PowerStation.

Warning

Observe normal precautions against static discharge to prevent

damage to the PowerStation or the backlight assembly.

Before beginning the procedure, turn off the unit and disconnect the

PowerStation from the power source. You must also remove the unit from

its enclosure (if installed) to gain access to the display. Consult the Power-

Station Installation Instructions if you need help with the removal.

This procedure requires a slotted head (#2) screwdriver.

1. Unscrew the four large captive backshell screws located at each corner

of the PowerStation.

2. Open the PowerStation so that you have access to the entire display.

The picture below shows a good setup for the bulb replacement.

Important Do not touch any of the exposed components on the backlight

display, or damage to equipment may result.

Lower Bulb Slot

Backlight Power

Connectors

Upper Bulb Slot

A3-05191-100

Table of Contents

Do you have a question about the PowerStation P7 Series and is the answer not in the manual?

Page 1 P 7 B a c k l i g h t B u l b R e p l a c e m e n t Background This document describes the procedures required to replace the backlight bulbs (model number BLR-6070) in the P7 TFT PowerStation. Warning Observe normal precautions against static discharge to prevent damage to the PowerStation or the backlight assembly.
Page 2 P7 Backlight Bulb Replacement Removing the Bulbs After the faceplate is removed from the unit, the backlight bulbs are acces- sible. CTC recommends that you replace both bulbs at the same time. Follow these steps to remove the old bulbs: 1.
Page 3 P7 Backlight Bulb Replacement Replacing the Bulbs Replacing the bulbs requires that you know which bulb goes in which slot. The bulb replacements are designed to fit only in the appropriate slot. Follow these steps to correctly insert the new bulbs. 1.
Page 4 P7 Backlight Bulb Replacement Computer Technology Corporation...