Advertisement
PowerStation Flash Memory Replacement
Background
Electrostatic Discharge Precautions
Computer Technology Corporation
This document describes the procedures for replacing the flash memory on
PowerStations. The P2, P3, and P5 PowerStations come equipped with
flash memory in place of a hard drive. This section describes how to
remove and replace flash memory for these units.
This procedure requires the following tools:
•
Slotted head (#2) screwdriver
•
Phillips head (#0) screwdriver
•
Quarter inch nut driver
Important The PowerStation uses special flash memory SIMM modules that
are available from CTC. Using flash memory modules from a
different source will cause unreliable memory storage. Also, CTC
cannot guarantee the integrity of backup operations.
Before you begin removing or replacing the flash memory, be sure to back
up any important data or Interact projects on the existing flash disk. Refer
to the Interact Project Manager User Guide for details on backing up
Interact projects.
Modern integrated electronic devices, especially CPUs and memory chips,
are extremely sensitive to electrostatic discharges (ESD) and fields. Before
you disassemble the PowerStation, be sure to follow these simple precau-
tions to protect you and the PowerStation from harm resulting from ESD.
1. To avoid electric shock, always disconnect the power from the Power-
Station before you remove the backshell cover or separate the back-
shell from the front panel. Do not touch any components of the CPU
card or other cards while the PowerStation is on.
2. Disconnect power before making any hardware configuration chang-
es. The sudden rush of power as you connect a jumper or install a card
may damage sensitive electronic components.
3. Only handle internal components in an ESD-safe location using appro-
priate grounding methods.
•
Always ground yourself to remove any static charge before you
touch the CPU card.
•
Be particularly careful not to touch the chip connectors.
A3-05197-100
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CTC Union PowerStations P3
Summary of Contents for CTC Union PowerStations P3
-
Page 1: Electrostatic Discharge Precautions
PowerStation Flash Memory Replacement Background This document describes the procedures for replacing the flash memory on PowerStations. The P2, P3, and P5 PowerStations come equipped with flash memory in place of a hard drive. This section describes how to remove and replace flash memory for these units. This procedure requires the following tools: •... - Page 2 PowerStation Flash Memory Replacement • Keep any card in its anti-static packaging when it is not installed in the PowerStation, and place it on a static dissipative mat when you are working on it. • Wear a grounding wrist strap for continuous protection. Disassembling the PowerStation If you have read and understand the ESD safety precautions, you are ready to disassemble the PowerStation.
- Page 3 PowerStation Flash Memory Replacement System Support Card. flash memory module System Support card 2. Push outward on the socket ejectors. It might be necessary to use a small screwdriver or the tip of a pen to push on the ejectors. 3.
- Page 4 PowerStation Flash Memory Replacement Setting the Flash Memory Jumpers Like most PCs, the PowerStation uses jumpers to set addresses and enable or disable various functions of the system. The PowerStation has four sets of jumpers for configuring the serial ports, touch screen, and flash memory (if available).
- Page 5 PowerStation Flash Memory Replacement flash setup disk. This format procedure will erase all data on the module. Important DO NOT use the PowerStation's DOS Format command to format the flash memory. 1. Insert the flash setup disk into the PowerStation’s floppy drive. 2.
- Page 6 PowerStation Flash Memory Replacement Computer Technology Corporation...
Need help?
Do you have a question about the PowerStations P3 and is the answer not in the manual?
Questions and answers