Maintenance; Environmental Protection - Ryobi CCG-1801 User Manual

EN
FR DE ES IT NL
The motor will shut off automatically when a caulk tube
becomes empty. Pull the plunger rod back and replace
the caulk tube as necessary.
To end the caulk bead, release the switch trigger.
Draw a moistened finger or other "smoothing tool"along
the caulk bead after applying. This will help the caulk
adhere to the application surfaces and will create a
clean, finished appearance.
Use a damp towel or rag to clean off any excess caulk.

MAINTENANCE

WARNING
When servicing, use only original replacement parts. Use
of any other parts may create a hazard or cause product
damage.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
WARNING
tery pack from the tool when cleaning or performing any
maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
To work properly, the plunger rod of the tool must remain
clean and free of all caulk and adhesive material. If
material does get on the plunger rod mechanism, clean
the material off according to the directions of the caulk or
adhesive manufacturer.
When the tool is shut off by the electronic overload
protection system, always wait for 3 to 5 seconds before
depressing the trigger for restart. Frequently depressing
PT DA SV FI NO RU
English
-
PL CS HU RO LV LT
and releasing the trigger under these circumstances may
cause interior damage to the caulk gun.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety Alert
V Volts
min -
Revolutions or reciprocations per minute
1
Direct current
EurAsian Conformity Mark
Ukrainian mark of conformity
CE Conformity
Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
4
ET HR SL SK BG UK TR EL