Related Manuals for ITW SIMCO ION COBRA
Summary of Contents for ITW SIMCO ION COBRA
- Page 1 COBRA Static Neutralizing Blow-off Gun with G165 and G255 Power Supplies INSTALLATION AND OPERATING INSTRUCTIONS C OBRA 5 10 05 99 Rev . D...
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. INTRODUCTION ....................3 2. SAFETY ....................... 4 3. SPECIFICATIONS ....................5 4. INSTALLATION ....................6 5. OPERATION ......................7 6. TROUBLESHOOTING .................... 8 7. MAINTENANCE ....................10 8. REPLACEMENT PARTS ..................11 9. WARRANTY ....................... 11 C OBRA 5 10 05 99 Rev . -
Page 3: Introduction
1. INTRODUCTION COBRA Static Neutralizing Blow-off Guns are lightweight, ergonomic com- pressed air guns designed for cleaning large surfaces. The COBRA Gun uses airfl ow amplifi cation in conjunction with ionization to produce an air blast that neutralizes static electricity and cleans at the same time. Included with the gun is a convenient hook for storing the COBRA Static Neutralizing Blow-off Gun and an accessory nozzle that produces a fan-shaped air blast. -
Page 4: Safety
2. SAFETY NOTE – Statements identifi ed with a NOTE indicate precautions necessary to avoid potential equipment failure. CAUTION – Statements identifi ed with a CAUTION indicate potential safe- ty hazards. NOTE – This equipment must be correctly installed and maintained. Ad- here to the following notes for safe installation and operation. -
Page 5: Specifications
3. SPECIFICATIONS COBRA Static Neutralizing Blow-off Gun Operating Voltage 5 kV AC (5 mA Max. Short Circuit Current) Operating Temperature 110 F (43 C) Maximum Operating Humidity 70% RH maximum, no dewing permissible Dimensions 6-1/8”L x 1-7/8”W x 6”H (Gun) 5-3/8”L x 3-7/8”W x 4-1/2”H Weight 1.5 lb (Gun w/ 20’... -
Page 6: Installation
4. INSTALLATION Power Supply Mounting: 1. Mount the power supply to a secure fl at surface such as a wall, bench or ma- chine frame (preferably away from operator contact). Secure with screws or bolts using the mounting fl anges at the base of the unit. Electrical Connections: 1. -
Page 7: Operation
Hook Installation: A mounting hook is included for hanging the COBRA gun against a wood or sheet metal surface when not in use. Locate the hook at the desired mounting level and mark hole locations. Drill 1/8” pilot holes and secure the hook with the screws and spacers provided. -
Page 8: Troubleshooting
6. TROUBLESHOOTING NOTE – Only qualifi ed service personnel are to perform troubleshooting tasks. Operational Check: 1. Rub a small strip of plastic fi lm until a static charge is developed (cellophane works well). The charge will be evident by the fi lm’s attraction to your hand. 2. - Page 9 If equipment fails to function properly: 1. Deenergize the power supply. 2. Ensure all ground connections are intact. 3. Check that all cable connections are tight. NOTE – FINGER TIGHTEN ONLY. 4. Energize the power supply (if equipped with an ON/OFF switch, ensure that it is in the ON position).
-
Page 10: Maintenance
7. MAINTENANCE NOTE – Only qualifi ed service personnel are to perform maintenance tasks. NOTE – Never use hard or sharp objects to scrape ionization points. CAUTION – Electrical Shock Hazard – Deenergize all power supplies before performing any maintenance tasks. CAUTION –... -
Page 11: Replacement Parts
8. REPLACEMENT PARTS/ADDITIONAL ITEMS Part Description Part Number Accessory Nozzle 4530287 Full Grip Lever Trigger 4530329 Mounting Kit (contains mounting hook and hardware) 5050316 SLCC HV Connector Kit 5050002 Cleaning Brush 4670204 Static Bar Checker 4000004 9. WARRANTY This product has been carefully tested at the factory and is warranted to be free from any defects in materials or workmanship. - Page 12 Simco-Ion 2257 North Penn Road Hatfield, PA 19440 (215) 822-6401 (800) 203-3419 www.simco-ion.com customerservice@simco-ion.com © 2011 Simco-Ion. Printed in the U.S.A. C OBRA 5 10 05 99 Rev . D...
Need help?
Do you have a question about the SIMCO ION COBRA and is the answer not in the manual?
Questions and answers