Advertisement
4. Place these spacers in their rightful holders
on the Add-On Board. These spacers do not
need any screws, they are self-retaining
spacers.
Once these are attached, you may fit the
ethernet module into the 10-pin, dual-row
connector labelled as "BLUEBOX".
5. This is what it looks like after fitted:
Please note: if you don't push the module in firmly, this will not work or show up as active.
You need to make sure the contacts mate properly. You can see whether the module is
properly connected by powering the box and observing whether the LEDs near the XLR
connectors are lit up.
Advertisement
