Advertisement
1.2. The Receiver
1
1. IMPULSE
Output for timing Impulse (Start gate, photocell – working / closing contact). Respect
the polarities.
2. DATA
Female Sub-D 9 : RS232 Output
3. POWER
To switch on the receiver (press for 3 seconds on POWER). The green LED is on.
To switch off the receiver, hold down
4. SET
To program the
during the changes.
5. TEAM
To check the programmed TEAM. The green LED corresponding to the code A, B,
or
6.
LED
LED control panel which shows the programmed
Received Impulse.
7. LED
Shows the transmission mode :
8. LED
LED control panel which shows the Receiving Level and/or possible interferences
created by other radio signals.
9. BUZZER
To enable or disable the Buzzer
10. TEST BATT
To check the Battery status. The Level will be displayed with the 4 LED's for 4
seconds:
-
-
-
-
-
TAGHeuer Timin
6
5
4
TEAM
(A, B, C, D) and to switch off the receiver. Hold down
D
is on. To change the code, hold down
4 LED's on = 80-100%
3 LED's on = 60-80%
2 LED's on = 40-60%
1 LED on
= 20-40%
1 LED on
= 0-20% power remaining
7
8
9
10
3
SET
and press POWER.
SET
and press TEAM.
TEAM
IMPULSE
or
DATA
2
SET
or CHANNEL. Also shows the
Page 4 / 8
C
Advertisement
