Advertisement
1. Functions
1.1. The Transmitter :
9
6
5
4
11
1. IMPULSE
2. DATA
2. POWER
4. SET
5. TEAM
6. CHANNEL
7. TEST
8. TEST BATT
9. LED
10. LED
11. CHARGE
.
TAGHeuer Timin
10
Input for timing Impulse (Start gate, photocell – working / closing contact). Respect
the polarities.
Male Sub-D 9: RS232 input for DATA transfer
To switch on the receiver (press for 3 seconds on POWER).
The green LED is on.
To switch off the receiver, hold down SET and press POWER.
To program the
TEAM
Hold down
SET
during the changes.
To check the programmed TEAM.
To change the code, hold down
To check the programmed CHANNEL.
To change the CHANNEL, hold down
For testing the Impulse transmission only. The reception level will be displayed for
0.2 seconds on the receiver. You'll also get an Impulse on the programmed
output.
To check the state of the battery. Press
displayed with the 4 LED's for 2 seconds.
LED control panel which shows the programmed
the transmitted Impulse.
Shows the transmission mode :
Charging status Leds.
The red led indicates that the battery is charging.
The charge is completed as soon as the green LED in on
7
8
3
(A, B, C, D) and to switch off the receiver.
SET
and press TEAM.
SET
and press
TEST BATT
IMPULSE
or
2
CHANNEL
: The Battery level will be
TEAM
or CHANNEL. Also shows
DATA
Page 3 / 8
1
Advertisement
