Table of Contents
Advertisement
ONLINE ELECTRONICS LTD
5. 3002RS BATTERY TEST AND REPLACEMENT
While the 3002RS receiver is ON press and hold the BATTERY TEST / RESET button. The
display bargraph will give an indication of the battery level. If the level is less than 50% then
the batteries should be replaced as per the steps below.
1.
Switch the unit OFF using the SENSITIVITY & ON/OFF control.
2.
The battery compartment is located on the side of the housing as shown in the graphic
below.
3.
The 3002RS battery compartment must only be opened in an indoor, clean and dry
environment.
4.
Unscrew the battery cover using a suitable large screwdriver and remove old batteries.
5.
Referring to the graphic below for guidance, insert the replacement batteries, observing
the correct polarity. Only use C Cell battery types. Always replace all of the batteries;
NEVER use a mix of new and used batteries. NEVER mix brands of batteries.
6.
Screw the battery cover back on.
7.
Switch the unit ON using the SENSITIVITY & ON/OFF control.
8.
Press and hold the BATTERY TEST / RESET button and confirm the battery level is a 100%.
9.
Switch the unit OFF using the SENSITIVITY & ON/OFF control.
6. MAINTENANCE
All Online Electronics Ltd products are designed to require minimum maintenance. The housing
should be cleaned using fresh water and cleaning agents as necessary. Do not use chemicals
which could be damaging to the housing, the nitrile rubber O-rings, the acrylic window, or any
connectors.
Frequent inspections should be made. A schedule for maintenance checks should be generated
according to the environment and frequency of use but should be regular enough to ensure the
equipment continues to operate in the designed manner. It is recommended that it should be
at least once a year.
If the unit is to be placed in storage for a long period of time ensure the unit has been cleaned
and the batteries are removed.
3002RS_5002_A01
Page 16 of 17
Advertisement
Table of Contents
