Advertisement
3
Registratio
PON
n
Optical
LOS
signal
WAN
WAN
Ethernet
LAN1
LAN2
2.4G
Wireless
5G
1.4 Interface/button Panel
Name
Connect to OLT by SC type fiber connector, single mode optical fiber
PON
cable.
Connect PC or other devices with Ethernet port by Cat5 cable, RJ-45
LAN1/2
connector.
DC 12V
Connect with power adapter. DC 12V, 1A.
Power supply switch.
ON/OFF
1. Press RST button over 10 seconds, onu restores factory default and
reboot.
RST
2. Press RST button quickly, onu reboots.
Pair
Press down WiFi pair button to begin pairing.
Press down WiFi button to enable/disable WiFi function.
WiFi
Website : www.baudcom.com.cn Tel: +86 21 37709251 Email:
2LAN+WiFi(dual band) Dual Mode ONU Quick Installation Guide_V1.1
On
The device is registered to PON system.
Off
Device is not registered to PON system.
Blink
Device is registering.
Blink
Device does not receive optical signal.
Off
Device has received optical signal.
On
WAN connection is up.
Blink
Data passing WAN connection.
Off
WAN connection is down.
On
Port is connected properly.
Off
Port connection exception or not connected.
Blink
Port is sending or/and receiving data.
On
WiFi is turned on.
Off
Device is power off or WiFi is turned off.
Blink
WiFi turned on and with ongoing data transmission.
Table 1 Panel Lights
Figure 4 Interface/button panel
Table 2
Interface/button Panel
Function
info@baudcom.com.cn
Skyper: robert.luo905
Advertisement
