Advertisement
Quick Links
Advertisement
Related Manuals for Ceyear 6481 Series
Summary of Contents for Ceyear 6481 Series
-
Page 2: Description Of Buttons
6481 Series Optical Fiber Fusion Splicer Quick Guide This carry-around Quick Guide briefly introduces the basic functions and operating methods of the instrument. For detailed instructions, please read the User Manual. Before using this product, be sure to read this guide carefully, and remember to keep this guide properly while carrying it around, so as to use and maintain this product properly by reading the guide at any time. - Page 3 Fusion Operation Preparation of Fiber 1. First fit the fiber into the heat-shrink tube. 2. Strip off the fiber and make sure that the coating residue on the stripped fiber has been removed. 3. Clean the fiber with anhydrous ethanol at a concentration of 99% or more.
-
Page 4: Cleaning And Maintenance
Cleaning and Maintenance Cleaning of V-groove The dirt on V-groove or fiber fixture may cause the fibers to deflect, resulting in larger fusion loss. Prepare a fiber and cut about 10mm from the bottom. Keep the fiber at a 45° angle. Clean the contaminants in V-groove by pushing it with the end of a well-cut fiber along the one direction. - Page 5 Cleaning of objective lens Lenses that are contaminated or damaged may result in high fusion loss or poor connections. Therefore, both objective lenses shall be cleaned regularly. Otherwise dust will accumulate eventually cannot removed. Before cleaning the objective lens, first turn off the power.
-
Page 6: Monitor Cover
Precautions Prevent the debris from falling into the instrument Debris falling inside the fusion splicer may cause malfunction, and the debris shall be prevented from falling into the red area in the figure below. Monitor cover Monitor cover protects the monitor during the daily operation of fusion splicer. If it is necessary to remove or install the cover, please proceed as shown below.