Summary of Contents for NewTec Design Audio CONO canto WiFi
Page 1
Please check if there are visible damages caused by transporta on. In this case, do not install the system but contact your supplier. Power connec on of the different WiFi speakers CONO canto WiFi CONO pendo WiFi WiFi Subwoofer SUB quadro WiFi Turn the switch ll you hear the “plop”...
Page 2
NEWTEC TRANSMITTER NEWTEC REMOTE CONTROL Transmi er Speaker Front Status-LED Status-LED Restart Connect Start Pairing Factory Se ngs End Pairing Restart SMA-RP IR Receiver Antenna Volume Up/Down Master Volume Status LEDs Mute Back Power Supply Audio In 5V DC (1A) Cinch RCA IMPORTANT: The remote is used to con- trol the transmi er, as well as the indivi-...
Page 3
Installa on guide WiFi speakers CONO canto WiFi: Clip the CONO canto WiFi speaker into the 3 phase ligh ng track. If you hear a “plop” from the speaker and the Led is flashing, you are on the correct phase and the speaker is connected to power.
Page 4
+/- bu ons (note that the "master volume" in the store is controlled by your audio device or by the WiFi transmi er.). ===================================================================================== Customer support: NewTec Design Audio GmbH www.newtec-audio.com Via Negrelli 13/C Tel. +39 0471 058065 39100 Bolzano – ITALY...
Need help?
Do you have a question about the CONO canto WiFi and is the answer not in the manual?
Questions and answers