Configuring Advanced Settings; Configuring Pppoe Settings - Huawei VS-EC-H24R User Manual

VS-EC-H24R&H28R&H29R
User Guide

Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you can
select the Main NIC to LAN1 or LAN2. By this way, in case of one NIC card
failure, the device will automatically enable the other standby NIC card so as to
ensure the normal running of the whole system.

Load Balance Mode: By using the same IP address and two NIC cards share the
load of the total bandwidth, which enables the system to provide two Gigabit
network capacity.

If the DHCP server is available, you can click the checkbox of
automatically obtain an IP address and other network settings from that server.

The valid value range of MTU is 500 ~ 9676.
Step 4
After having configured the general settings, click the "Apply" to save the settings.
----End

9.2 Configuring Advanced Settings

9.2.1 Configuring PPPoE Settings

Your DVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Step 1
Enter the "Network Settings" interface.
Menu > Configuration > Network
Step 2
Select the "PPPoE" tab to enter the PPPoE Settings interface, as shown in Figure 9-2.
Issue 04 (2013-06-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Network Settings
" "
DHCP to
165