Replace The Remote Control Battery; Troubleshooting - i-onik MSC-220 Manual

13 LINE IN socket
14 LINE IN cable
- LINE IN socket on the amplifier.
- HEADPHONE socket on an external audio device.

Replace the Remote Control Battery

The provided Remote Control allows the unit to be
operated from a distance.
Even if the Remote Control is operated within the

effective range (6m), remote control operation may
be impossible if there are any obstacles between the
unit and the remote control.
If the Remote Control is operated near other products

which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it
may operate incorrectly . Conversely , the other products
may operate incorrectly.
For First-time use:
The unit has a pre-installed lithium CR2025 battery.Remove
the protective tab to activate the remote control battery.
To Replace the Remote Control Battery:
1 Pull out the battery tray and remove the old battery.
2 Place a new CR2025 battery into the battery tray with
correct polarity (+/-) as indicated.
3 Insert the battery tray back into the slot.
Precautions Concerning Batteries
When the Remote Control is not to be used for a long

time (more than a month), remove the battery from
the Remote Control to prevent it from leaking.
If the batteries leak, wipe away the leakage inside

the battery compartment and replace the batteries
with new ones.
Do not use any batteries other than those specified.

Do not heat or disassemble batteries. Never throw

them in fire or water.
Do not carry or store batteries with other metallic

objects. Doing so could cause batteries to short circuit,
leak or explode.
Never recharge a battery unless it is confirmed to be a

rechargeable type.

Troubleshooting

To keep the warranty valid, never try to repair the system
yourself. If you encounter problems when using this unit,
check the following points before requesting service.
No power
- Ensure that the AC cord of the apparatus is connected
properly.
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
10