TREND TCH/PO/G12R Quick Start Manual

Rechargeable
Pocket Torch
TCH/PO/G12R
INST/TCH/PO/G12R v1.0
POCKET TORCH
REF. TCH/PO/G12R
Thank you for purchasing this Trend product,
which should give lasting performance if used
in accordance with these instructions.
Denotes risk of personal injury, loss
of life or damage to the tool in case of
non-observance of the instructions.

INTENDED USE

This accessory is intended to be used as
a torch only. The torch has High, Low and
Strobe light functions.

SAFETY

Read and understand the instruction sheet
carefully before using. This is a sensitive
precision tool. Do not disassemble or drop it.
Please note the magnets in the base. Store
out of reach of children. Do not use as a toy
or as a weapon.
PLEASE KEEP THESE INSTRUCTIONS IN
A SAFE PLACE.
Users must be competent in using
woodworking equipment before using our
products. Consider working environment
before using tools. Ensure working position
is comfortable and component is clamped
securely. Please keep children and visitors
away from tools and work area. All tools have
a residual risk so must therefore be handled
with caution.
CE DECLARATION CONFORMITY
This product conforms with EMC
Directive 2014/30/EU.

OPERATION

Mode: High – Low – Strobe – Off.
Press tail button switch on end of torch to
switch on/off. When on, the tail button will
glow green.
Charging
Rotate the tail cap of the torch to expose the
charging port. Use USB cable (supplied) to
connect with USB mains adaptor
(not supplied).
The tail button switch will flash green, which
means it is charging and will turn to green
when fully charged. Battery charge time can
take 2 to 2.5 hours.
During normal operating the green light will
start to dim when the battery life is getting low.
When the green light starts to flash you will
need to recharge the torch soon.

GUARANTEE

All Trend products are guaranteed against
any defects in either workmanship or material,
except products that have been damaged due
to improper use or maintenance.
© Trend Machinery & Cutting Tools Ltd. 2018 E&OE
® All trademarks acknowledged
Trend Machinery & Cutting Tools Ltd
Odhams Trading Estate St Albans Road
Watford WD24 7TR England
Tel: 0044(0)1923 249911
technical@trendm.co.uk
www.trend-uk.com
PTO