Related Manuals for Campbell Guardian
Summary of Contents for Campbell Guardian
- Page 1 Guardian Pedestrian Signal Installation Manual 906-0056 Revision A ● January 29, 2020...
- Page 2 Campbell Company. The information furnished herein is believed to be accurate and reliable. However, no responsibility is assumed by Campbell Company for its use, or for any infringements of patents or other rights of third parties resulting from its use.
- Page 3 Guardian Installation Manual Guardian Installation Manual 906-0056 Document Revision History Revision Revised By Date James Elfering – Added 5.0 Features 1/29/20 Guardian Guardian 400A 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 3 of 11...
-
Page 4: Table Of Contents
......................... 6 TANDARD OMPONENTS ........................... 6 NSTALLATION Post Installation ....................10 ........................10 PERATIONAL HECK Appendix A: Acronyms, Abbreviations & Definitions ..........11 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 4 of 11... -
Page 5: Introduction
Guardian Installation Manual Introduction Purpose of this document This guide covers the installation of the Guardian Pedestrian System. It does not cover the configuration of the Guardian. For details on configuring the Guardian, please see the User’s Manual. Additional Information •... -
Page 6: Installation
(left or right) requiring one security screw and a security driver. An Angle Mounting Kit for the Guardian Base Station is available if necessary to ensure a precise fit, especially on decorative or small diameter poles where the station needs to be angled to provide accurate directionality of the arrow. - Page 7 Guardian Installation Drill and Tap Pole 1. Refer to the Guardian Base Station Mounting Template for hole specifications. 2. Mark the point where the PPB will be centered 36” to 42” from the ground. 3. Drill and tap for a 1/4-20 screw 2” above PPB center.
- Page 8 2. Open the Pedestrian Signal Head Display and locate a ¼-20 tapped hole on the back wall close to the 120VAC three position barrier strip as shown in Figure 2. 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 8 of 11...
- Page 9 Figure 2. SPI Installed signal display. 6. Restore power to the signal head and verify that the station operates. Figure 3. SPI Wiring 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 9 of 11...
-
Page 10: Post Installation
7. After the Walk message, verify that an audible locator tone is present during the clearance (Flashing Don’t Walk). 8. Recheck all units for a full cycle to ensure all options and features operate as desired. 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 10 of 11... -
Page 11: Appendix A: Acronyms, Abbreviations & Definitions
Power Source that interfaces with Pedestrian Signal Head power for Interface (SPI) Base Station Interface. Station ID Identification number of station for location and custom messaging 906-0056 Guardian Installation Manual Rev A.docx © Dick Campbell Company 2020. All rights reserved Page 11 of 11...