YahBoom 6000200062 Use Precautions

Battery of Arduino Balance Car use precautions:
1. Please use the charger we provide to charge the car.
2. The car cannot be used while charging.
3. The voltage needs to be charged in time at around 9V. When the charging is
completed, the battery voltage is about 12.6V.
4. If you do not use the car for a long time, you should unplug the battery cable
from the bottom plate of the car. Because even if the car is in standby, the
battery will be worn out.
5.If you have not used the car for a long time, you need to fully charge the
battery before using it next time, then use the car.
6.When the battery is charging, the charger indicator lights up red,the indicator
will turn green after charging is complete.After charging is completed, the
charger and power supply should be unplugged in time to avoid overcharging
and damaging the battery.
7.The charging port of the car is on the bottom plate, not on the UNO board.
The charger needs to be plugged into the bottom plate to charge. If the charger
is plugged into the UNO board, the car cannot be charged.
The charging method is as shown below:
www.yahboom.com