Maintenance And Cleaning - Promaker PRO-LO300 User Manual

1. Open the back pin (5) and insert the
sander sheet edge so it is centered
and aligned with base.
2. Close back pin and place base on
flat surface, pressing the sheet.
3. Open front pin (5.1) , then with the
rest of sander sheet wrap front base
and insert sheet into front pin.
4. Close tip and check that the sander
sheet is properly aligned and tense
against the base and that it is fully
covered.
Abrasive paper (for sanding):
1. Only use good quality abrasive
paper, which will increase performance
and will allow shorter task.
2. Use abrasive papers of grain -40
-60 or -80 for removing important
quantity of material.
3. Use grain 120 for finish operations.
4. Replace sandier sheet if it was
worn, blocked or damaged.
Note: Sander sheets and base
cushion are consumable items.

MAINTENANCE AND CLEANING:

Warning!
Unplug the tool before any adjustment,
service or maintenance.
This electric tool does not require
lubrication or special maintenance.
1. If the cable got damaged, it should
be replaced by the manufacturer,
service agent or qualified person in
order to prevent risk of electric shock.
2. Keep safety devices, ventilations
and engine casing as dust free as
possible.
3. Empty and clean filter bag frequently.
4. Clean the tool periodically with a
wet cloth and neutral soap only.
5. Do not use cleaners or solvents,
these may attack plastic parts.
6. Prevent inlet of any liquid, do not
submerge any part of the tool.
7. Never use
combustible solvents near an electric
tool.
ESPECIFICATIONS
Voltage /
Frequency
Power
Speed
Weight
WASTE AND
ENVIRONMENT:
When this tool has arrived to the
end of its useful life or its repair is
not profitable, should be throw
away according to local regulations
in-force.
Devices marked with the adjoining
symbol should not be disposed off
in domestic garbage
inflammable or
120V / 60Hz
300W / 2.5AMP
6000-
12000opm
4.53Lb
CARE OF
5