Promaker PRO-TP800 User Manual page 7

properly wired and in good condition.
Always replace
extension cord or have it repaired by
a qualified electrician before using
it. Protect your extension cord from
sharp objects, excessive heat and
damp or wet areas.
Use a separate electrical circuit
for your power tools. This circuit
must not be less than 14 gauge
wire and should be protected with
either a 15 AMP time delayed fuse
or circuit breaker. Before connecting
the power tool to the power source,
make sure the switch is in the OFF
position and the power source
is the same as indicated on the
nameplate. Running at lower voltage
will damage the motor.
SYMBOLS
WARNING: Some of the following
symbols may appear on the
drill. Study these symbols and
learn their
interpretation of these symbols
will allow for more efficient and
safer operation of this tool.
V Volts
A Amperes
Hz Hertz
W Watts
kW Kilowatts
Microfarads
L Liters
a damaged
meaning. Proper
kg Kilograms
H Hours
N/cm2 Newtons per square
centimeter
Pa Pascals
OPM Oscillations per minute
Min Minutes
S Seconds
Alternating current
C, A.
Three-phase alternating
current
Three-phase alternating
current with neutral
Direct current
No load speed
Alternating or direct
current
Class II construction
Splash-proof construc-
tion
Watertight construction
Protective grounding
at grounding terminal,
Class I tools
Revolutions or reciproca-
tions per minute
Diameter
Off position
Arrow
Warning symbol
Wear your safety
glasses
7