Boulevard DVP60LKR-1 Installation Instructions Manual

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE.

CARTON CONTENTS:

• Rear Porcelain Panel
• Left Side Porcelain Panel
• Right Side Porcelain Panel
• Screw Package
• Side Retainer Bracket (Qty. 2)
Installation
Sharp edges! To avoid injury, wear safety gloves to install liner.
1. Refer to the fireplace installation manual for removal of the
Barrier and Glass Door assemblies prior to installation of the
porcelain liner kit.
2. Remove decorative media from hearth and burner cover.
3. Carefully unpack the porcelain liners, verify that all components
are included, and inspect for hidden damage, prior to installation.
4. Remove the front Light Cover by lifting it up and out, then set
it aside.
5. Install the two Side Retainer Brackets at the front left and right
side openings of the firebox with two 5/16 X 1/2" screws each.
These brackets must be installed so the angle break is facing
forward. See Figures 1 and 2.
INSTALL WITH
ANGLE FORWARD
35736-1-0220
INSTALLATION INSTRUCTIONS
DVP60LKR-1 PORCELAIN PANEL KIT
FOR USE ON: DVLL60BP SERIES FIREPLACES ONLY

TOOLS NEEDED:

• Gloves
• Eye Protection
• 5/16" Hex Driver
CAUTION
INSTALL WITH
ANGLE FORWARD
Figure 1
Figure 2
Empire Comfort Systems Inc. • Belleville, IL
PORCELAIN PANEL KIT
6. Before installing the Rear Panel, remove the two 5/16 X 1/2"
pre-installed screws from the back wall of the firebox. These
two screws are located approximately 17-3/4" above the
burner cover, and 24" apart. These screws are used to secure
the Rear Liner panel .
7. Check the Rear liner panel to make sure it is not bowed.
NOTE: The bottom edge has eight tabs that must be in
a straight line to match up with the slots at the rear of the
firebox. Check to make sure the insulation on the back of the
panel remains in place before installation.
8. Install the Rear Panel by aligning the eight tabs on the bottom
edge with the eight slots in the back rear of the firebox. NOTE:
The eight slots are located behind the burner cover plate. See
Figure 3.
S L O T S
T A B S
Figure 3
Page 1