Advertisement
Quick Links
Advertisement
Summary of Contents for 7-BIT Wicher CDTV
- Page 1 Wicher CDTV 8MB SDRAM, IDE Controller USER GUIDE Version 1.1...
- Page 2 Overview Wicher CDTV card has been designed for the Amiga CDTV line of computers. It should be installed in the original CPU socket that is located on the Amiga’s motherboard. Wicher CDTV provides 8 MB of additional SDRAM FAST RAM memory, and the IDE controller. In order to properly support the IDE controller, Kickstart 2.05 (37.350) or newer is required.
- Page 3 Installing the CPU in Your Wicher CDTV Card Wicher CDTV card supports the following processor models: MC68000, MC68HC000, and MC68010 in the DIL-64 packaging. The CPU should be installed in the socket located on the card, in the position indicated in the following picture.
- Page 4 Wicher CDTV card has been designed for installation inside the Amiga CDTV computer. After removing the original MC68000 CPU, one can start the proper Wicher CDTV card installation. In order to carry it out, the pins found at the bottom side of the card, should be carefully inserted into the U51 chip socket, and then the card should be gently pressed, until it seats firmly.
- Page 5 Please take special care when installing the PCB board and connecting the signal cables. Incorrect installation may result in damaging the computer or the turbo card. When Wicher CDTV card is properly installed, you can finally put it through its paces. Wicher CDTV...
- Page 6 X2 Jumper Settings Position 0 – enable / disable RAM Position 1 – enable / disable IDE controller Wicher CDTV...
- Page 7 IDE Device Installation Wicher CDTV’s built-in IDE controller uses the IDE44 port that is compatible with devices such as hard drives and IDE- CF/IDE-SD adapters. When installing any IDE device, please ensure the correct orientation of the pin no. 1 by following the labeling on the Wicher CDTV card.
- Page 8 7-BIT ul. Miłostowska 23/7 Wrocław, Polska, EU BDO: 000007249 https://7-bit.pl Wicher CDTV...